Woojer Series 4 devices can be connected to a source device using either a 3.5mm auxiliary audio cable, a USB-C cable, or using wireless Bluetooth. Below you will find instructions on how to connect your Woojer to your Quest using these different methods.

The information in this article should be relevant for the Quest, Quest 2, Quest Pro, and Quest 3.

Please understand that the Woojer works as an audio output device, and once connected to your Meta Quest, it currently disables the Quest's internal audio.

Currently, you must connect headphones directly to the Woojer for the audio output.

A future Meta Quest update may allow you to use the Woojer without disabling the Quest's internal audio, but we cannot promise anything about that.

All information presented in this article reflects the manual pairing instructions. You can also connect and pair Bluetooth headphones to your Woojer using the dedicated Woojer application. See more information here.

TABLE OF CONTENTS

• Connecting with a 3.5mm cable to your Quest
• Connecting with Wireless Bluetooth to your Quest
• Connecting Bluetooth headphones to the Woojer

Connecting with a 3.5mm cable to your Quest 2/Quest 3

1. Press and hold the Woojer's power button for 5 seconds until the Woojer turns on.
2. Connect the 3.5mm auxiliary cable. One end goes to your Meta Quest 3.5mm audio output jack, and the other end goes to your Woojer's dedicated audio input jack.
3. Connect your headphones to the Woojer, using either a 3.5mm cable or using wireless Bluetooth. You can learn more about connecting your headphones using Bluetooth at the bottom of this article.

On your Woojer Series 4, the left side of the LED ring indicator should switch from blinking blue to solid blue, confirming that an audio source is connected.
We recommend using the High-Quality 3.5mm auxiliary audio cable offered on our website.

Connecting with a USB cable to your Quest 3S

1. Press and hold the Woojer's power button for 5 seconds until the Woojer turns on.
2. Connect a USB type C cable. One end goes to your Quest 3S USB jack (the same one used to charge the Quest 3S), and the other end goes to your Woojer's data USB type C port (for the Woojer Strap 4, it is the only USB port. For the Woojer Vest 4, it is the one on the control unit, in the front part of the Vest).
3. Connect your headphones to the Woojer, using either a 3.5mm cable or using wireless Bluetooth. You can learn more about connecting your headphones using Bluetooth at the bottom of this article.  

On your Woojer Series 4, the left side of the LED ring indicator should switch from blinking blue to solid blue, confirming that an audio source is connected.

Connecting with Wireless Bluetooth to your Quest

1. Turn the Woojer device on.
2. Access your Meta Quest's Bluetooth settings and locate the "Woojer Strap 4" or "Woojer Vest 4" to initiate pairing with the device.
3. Once paired, the left side of the LED ring indicator should switch from blinking blue to solid blue, confirming that an audio source is connected.
4. Connect your headphones to the Woojer, using either a 3.5mm cable or using wireless Bluetooth. You can learn more about connecting your headphones using Bluetooth at the bottom of this article. 

Connecting Bluetooth headphones to the Woojer

1. Turn on your Woojer.
2. Press and hold the power button AND the volume up button of your Woojer for 5 seconds simultaneously.
   The right side of the LED ring will begin to blink rapidly with red and blue, indicating the headphones pairing mode.
3. Set your Bluetooth headphones into pairing mode and place them near the Woojer. 
4. Both devices will pair within 30 seconds.
5. Once paired, the he right side of the LED ring will become solid blue, confirming the connection to an audio output.